4 - 4 Omnii Hand-Held with Windows CE 6.0 User Manual
Attaching the Pistol Grip
NOTE
Prior to installation, make sure the trigger mechanism is securely snapped into the pis-
tol grip body and that the trigger operates properly.
The pistol grip is attached to the back of the Omnii using the four threaded inserts in the upper part of the Omnii
casing (see
Figure 4-2 Attaching the Pistol Grip on page
•
Position the pistol grip so that it fits snugly over the back of the unit and the holes in the pistol grip are
aligned with the threaded inserts on the back of the hand-held.
•
Using a Phillips screwdriver, tighten the screws to a torque of 3 lbs-in (3kgf-cm) to secure the pistol grip
in place.
Attaching the Pistol Grip
Figure 4-2
Carrying and Protective Accessories
NOTE
The Omnii Hand-Held Computer is a body worn device, and to maintain compliance
with the FCC RF exposure guidelines, use a Motorola approved carrying case. Use of
non-approved accessories may violate FCC RF exposure guidelines.
There are several Omnii carrying and protective accessories to help you work safely and comfortably.
Attaching Carrying Accessories
If your Omnii is not fitted with a hand strap, you can install it using the carrying accessory kit supplied.
You'll need:
• A Phillips head screwdriver.
IMPORTANT
Do not use adhesives such as Loctite to secure screws on carrying acces-
sories. These chemicals may damage the plastic casing.
4-4). Four M3x6 Phillips head screws are provided.