Barcode Settings; Scanner Options - Motorola 7545MBW User Manual

Barcode Settings

The Scanners icon in the Control Panel provides dialog boxes in which you can tailor barcode scanner config-
urations and choose the barcodes your scanner will recognize.
The parameters are preset with the default settings of the decoded scanner installed in the unit. For a listing of
available scanners and their specifications, please refer to
IMPORTANT

Scanner Options

The drop-down menu to the right of the Scanner option allows you to choose configurations for one of the
following scanner types, depending on what is installed in/on your hand-held: Decoded (internal), Decoded
(HHP), Decoded (Intermec ISCP, and Non-decoded Scanners.
The symbologies listed change to reflect the scanner you choose and the barcodes it supports. Always defer to
your barcode scanner programming manual when in doubt about the availability or settings for any parameter.
NOTE
Your Omnii comes preconfigured from the factory for internal scanner types.
The type of scanner installed can be determined from the System icon in the
Control Panel, under the System Properties tab.
IMPORTANT
Keep in mind that some barcode types are only available when an internal imaging scanner is installed. All
internal scanners can be configured using these dialog boxes.
To enable a newly-installed scanner, press and hold down the [FN]
key and the [Power] key simultaneously for a minimum of three
seconds.
For information on configuring the Options, Translations, and Ports
settings, see "Scanners" on page
To improve the decode speed and performance, enable (set to on)
only those codes that are required by the application.
Scanner Settings C - 3
Appendix E: "Omnii Specifications".
3-55.