Magnetic Stripe Reader; Attaching And Removing The Msr; Using The Msr - Motorola MC9500-K User Manual

8 - 14 MC9500-K Mobile Computer User Guide

Magnetic Stripe Reader

This section describes how to set up and use the snap-on (Magnetic Stripe Reader (MSR) with the MC9500-K. The
MSR snaps on to the back of the MC9500-K and removes easily when not in use.
When attached to the MC9500-K, the MSR allows the MC9500-K to capture data from magnetic stripe cards. To
download sample MSR data capture software, visit the Support Central web site.
To charge to MC9500-K with the MSR attached,
NOTE While the MC9500-K with MSR is attached to ta Single Bay USB Cradle, a Four Bay Ethernet Cradle or a
USB/Charging Cable, Operation of the MSR is disabled.
If attaching the MC9500-K with the MSR onto a Four Bay Cradle, remove the optional guide cup before
attaching the MC9500-K.

Attaching and Removing the MSR

To attach, slide the cleat of the MSR into the interface pocket of the MC9500-K and snap into place.
Release Button
MSR Installation
Figure 8-11
To remove the MSR, press the release button and lift off the MC9500-K.

Using the MSR

Install an MSR enabled application onto the MC9500-K.
To use the MSR:
Attach the MSR to the MC9500-K.
1.
Power on the MC9500-K.
2.
Launch the MSR application.
3.