Table of Contents
Advertisement
The notes on fi rst installation are unifi ed once again from this point!
When you have fi nished confi guring the satellite press the
matically calls up the selection menu for the channel search:
FIRST INSTALLATION
Satellites and position
Use the
(selection from 17 pre-programmed options).
LNB settings
Here use the
type used in your system. The choice is between
"Universal" and "User-defi ned".
Universal:
No further input required, since all necessary
frequency ranges are covered by a universal LNB.
User-defi ned:
If you choose not to use a universal LNB, you
must here set the frequency ranges for which your
LNB was confi gured.
Use the
to be changed (low, high or limit frequency).
Use the
to set the exact frequency for which your LNB was
confi gured.
Test transponder
To check whether the settings that you have
made
to
Use the
transponder from the various ones listed. If your
settings are correct, you will see at the top right of the
screen the live signal of a channel for the currently
selected transponder.
If you are not receiving a signal, check your
settings again and if necessary call for expert
help.
You have now completed all settings for the fi rst
satellite. Press the
"Satellite Selection Menu" and perform the settings
in the same way for the remaining satellites.
buttons to set the desired satellite
buttons to select the LNB
buttons to select the frequency range
buttons or the digital input buttons
are
correct,
use
move
to
the
"Test
buttons to select the required
(green) button. The receiver then auto-
the
buttons
transponder"
fi eld.
button to return to the
19
Hide quick links:
Advertisement
Table of Contents
