Registering Users - Konica Minolta magicolor 8650 User Manual

Authentication unit (IC card type AU-201)

Registering users

!
Detail
In order to register users with PageScope Data Administrator, this device must be connected to the
USB port of the computer, and the computer and machine must be connected over a network.
Note
When the machine is turned off, then on again with the power switch, wait at least 10 seconds to turn
the machine on after turning it off. The machine may not operate correctly if it is turned on immediately
after being turned off.
Hold the plug when plugging and unplugging the USB cable, otherwise the cable may be damaged.
Reminder
Do not connect other USB devices to the same port where this device is connected. If enough USB
power is not provided, this device may not operate correctly.
When using a USB hub, be sure to use a self-powered USB hub that can provide 500 mA or more.
After connecting this device, wait at least 5 seconds before operating it.
1
If this device is connected to the machine, turn off the machine with the power switch, and then
disconnect this device.
– If this device is connected to the computer, continue with step 4.
2
Turn on the machine with the power switch.
3
Connect this device to the USB port of the computer installed with PageScope Data Administrator.
4
Start up PageScope Data Administrator, and then import the device information for the machine.
– For details on importing the device information, refer to the User's Guide for PageScope Data
Administrator.
8650
Network
machine
USB
Computer This device
15
15-13