Adjusting The Eaz For D310 - Philips ErgoLine D330 Manual

Adjusting the EAZ for D310:

The two settings EAZ can be programmed as follows:
1 place handset on hook
2 press PROGRAM key
3 press "9"
4 press PROGRAM key
5 press a character to change the setting for EAZ.
6 The character can be a digit, 0 to 9, or *.
7 Press PROGRAM key to select this setting
The default setting is '*' for EAZ
EAZ
'0'-'9'
'*'
Notes:
• On an outgoing call set up from the terminal, the PABX (of the iS3000 series)
looks for a directory number (DNR) that is defined for the U
that matches the EAZ. If not found the PABX continues to allocate any other
DNR at the U port or S
PN
terminal, connected via the U
should be set as * or 2 (2 is the default value of the PABX). For EAZ-2 (D320) no
value needs to be specified.
• A 4 wire terminal, connected via the S
EAZ (D310) or EAZ-1 (D320) of the first terminal be set to 2, and the EAZ (D310) or
EAZ-1 (D320) of the second terminal be set to 3. (Connecting 2 terminals in this
way is called co-location. Co-location is only possible with 4 wire terminals).
EAZ-2 is not required.
This is however not a rule. For example, if terminal-1 gets EAZ-1=2 and EAZ-2=3,
while terminal 2 gets EAZ-1=3 and EAZ-2=2, then on an incoming call for
terminal 1, terminal 2 will ring simultaneously. On an incoming call for terminal 2,
terminal 1 will ring simultaneously. The call can be answered by both terminal 1
and terminal 2. This is of course is only possible when terminals are co-located
and when these terminals support separate EAZ adjustment for incoming and
outgoing calls. Only the D320-4W supports both these conditions.
• In case of malfunction (for example, incoming calls are not accepted, or the
terminal sets up calls with the wrong directory number) check the EAZ setting.
Outgoing call set up is
made with: (see
remarks)
EAZ: '0'-'9'
'0'
T 5.3: EAZ
ABLE ADJUSTMENT FOR
-bus that matches the service profile. So for a 2 wire
0
interface, the EAZ (D310) or EAZ-1 (D320)
PN
0
Customer Engineer Manual
Terminal accepts incoming
calls with:
EAZ: '0'-'9'
All incoming calls are
accepted
D310
PN
interface, normally requires that the
ErgoLine D310/320
port or S -bus and
0
Page 5-9