D330 Terminal Endpoint Identification (Tei) - Philips ErgoLine D330 Manual

D330 Terminal Endpoint Identification (TEI)

In the specification of the terminal message protocol (TMP) a B channel is
identified by a port number. The ErgoLine terminal uses fixed TEIs for B channel
allocation.
For ErgoLine D330 terminals the TEI can have two different values:
0 = B channel 0
1 = B channel 1
When 0 or 1 is selected only one B channel is used for voice. The TEI setting should
only be changed during installation. This is done as follows:
1. Press the Options key then scroll down until the Features option is displayed
and press the OK key.
The following display will appear on the screen:
[ Scroll, OK accept]
Togglelist?
2. Scroll down until the SetPhone option is displayed and press the OK key.
The following display will appear on the screen:
[ Scroll, OK accept]
Set language?
3. Scroll down until the Select mode option is displayed and press the OK key.
The following display will appear on the screen:
[Enter Password]
4. Enter the service password of the set, 12687.
Note: This password cannot be changed. It is for the use of maintenance
personnel only
The following display will appear on the screen:
[Press OK to accept]
*****
5. Press the OK key. The display will return to idle indicating that the Service Mode
is active.
ErgoLine D330/D340
Customer Engineer Manual
⋅
Page 2-7