System Requirements - Philips ErgoLine D330 Manual

7. Press the Change (soft) key to change the TEI number, then press the OK key
to accept the new setting.
The following display will appear on the screen:
Terminal endpoint i.d. set!
Downl. Req
Note: This display will be shown only for a few seconds.
Note: The TEI must be granted by the network. If the TEI is not supported, the
display will show the message TEI Denied indicating that another terminal
already occupies the specified TEI i.d. The terminal TEI i.d. needs to be
changed to a unique value before it will be accepted.
If the set remains non-operational after setting the TEI, the message TEI
Denied can be displayed by pressing the down arrow key.
Note: If the TEI has been changed it is necessary to remove and re-insert the
line cord for the change to take effect.

System Requirements

The following firmware and software levels (or higher) are required to support
ErgoLine:
• CPU package SSW805.24.d
• DLX-U firmware 300.103
• PPU package PMC 405.07 or PPU 162.07 or PPU 262.07
• DTX-I firmware 203.601
TEI Clean
ErgoLine D330/D340
Customer Engineer Manual
à
[ Options]
Cancel
Page 2-11