Philips ErgoLine D330 Manual page 58

ErgoLine D330/D340
Customer Engineer Manual
S8
S9
S10
S11
S12
Note: S6 to S11 are not applicable to ISDN/Digital terminals
N H R
OT ALL OF THE AYES
OR MESSAGES FROM THE
V
APPLIED
0 OK
1 CONNECT
2 RING
3 NO CARRIER
4 ERROR
5 CONNECT 1200
7 BUSY
10 CONNECT 2400
11 CONNECT 4800
12 CONNECT 9600
13 CONNECT>xxxx
Page 2-38
Not used Pause Duration for Dial Delay. Not
supported. Default is ASCII 1
Not used Reaction Time to Received Carrier.
Default is ASCII 6
Not used Time Delay from Loss of Carrier to
Clearing of Connection. The synchronisation
may be lost for up to 3 seconds.
Default is ASCII 7
Not used Duration and Interval of the MFV-
Tone. Default is ASCII 70
Maximum Supervision Time for an escape
sequence. Default is 0.5 seconds (the time is
given in hundredths of a second)
T 2-15. R
ABLE
C . R
ESULT ODES ARE USED
S . I
WITCH F AND WHEN THE
(V0 & V1)
COMMANDS
Command executed
Connected at 0 .. 300 bit/s
Incoming call
No synchronisation or synchronisation lost
Error in given command
Connected at 1200 bit/s
Busy
Connected at 2400 bit/s
Connected at 4800 bit/s
Connected at 9600 bit/s
Connected at xxxx bit/s (over 9600 bit/s)
C
ESULT ODES
C
ESULT ODES ARE SENT AS REACTIONS TO COMMANDS
R C
ESULT ODES ARE EXPRESSED DEPENDS UPON THE
X (X0, X1 & X3).
AND THE COMMANDS