International Character Selection - Philips ErgoLine D330 Manual

International Character Selection

International characters can be selected on the ASCII keypad by pressing the
grey key, located at the top right of the keypad, followed by one of the keys
marked with a coloured circle. (For example, to select the character è, press the
grey key then the E key. Continued pressing of the E key will toggle through the
choices available for this key combination.) If a message contains special
characters, these special characters can be received by other equal ErgoLine
terminals. However they cannot be received by SOPHO Sets or the SOPHO DECT
handsets.
F 2-12. I
IGURE NTERNATIONAL
Relationship of Keys on ASCII Keyboard to Terminal Keys
The following keys perform the same function on the ASCII Keyboard as the
equivalent keys on the ErgoLine terminals. Those keys are: Exit, Backspace, Cursor
Keys, OK , LNR, Shift and the Softkeys. Refer to the User Guide for details.
Channel Selection
The ASCII Keypad can communicate with the ErgoLine terminal over one of three
channels. When selecting a channel, take note of the channels being used by
other ErgoLine terminals and ASCII Keypads working nearby. Select a channel
which will not interfere with the operation of other terminals.
To select a channel for the ASCII Keypad, proceed as follows:
1. Open the battery cover on the rear of the ASCII Keypad.
2. Remove the batteries.
3. Using a narrow object (such as
the point of a pen) set the
slide switch to channel 1, 2 or
3 as required. The default
setting is 3 on both terminal
and ASCII keyboard.
4. Replace the batteries.
5. Replace the battery cover.
6. Set up the ASCII channel on
the ErgoLine terminal to match
the keypad channel setting via the softkey menu.
C S
HARACTER ELECTION
ErgoLine D330/D340
Customer Engineer Manual
International Character
Selection Key (coloured grey)
Page 2-43