Neutral Start Interlock (Nsi); Installation/Adjustment - Suzuki DF9,9 Service Manual

NEUTRAL START INTERLOCK (NSI)

INSTALLATION/ADJUSTMENT

1. Shift into "NEUTRAL" position.
2. Install the NSI cable in the recoil starter, the clutch notch
lever 1, the stopper arm 2 and the cable bracket (stator
base) 3.
3. Turn the adjustment nut 4 to align the slot on the stopper
arm 2 with the punch mark 5 on the recoil starter case.
4. Pull the recoil starter and make sure that the starter does not
work when the shift lever is in "FORWARD" and "REVERSE"
position.
5. Tighten the lock nuts 6.
6. Apply SUZUKI WATER RESISTANT GREASE to the inner
cable, the cable end and cable holding area.
 99000-25161: SUZUKI WATER RESISTANT GREASE

If the NSI cable is removed or left without correct
adjustment, there is a high risk of losing one's bal-
ance and/or being thrown overboard if the motor
starts in gear.
2
5
RECOIL STARTER 5-9
4
6
3
1