8. Remove the two (2) bolts securing fuel hose clamp 9.
9. Remove two (2) bolts and handle cover 0.
Remove tiller handle and throttle cable assembly A.
INSTALLATION
Installation is reverse order of removal with special attention to
the following.
• Tiller handle
• Place bush 1, bush 2 and friction rubber 3 on tiller han-
dle.
• Install tiller handle and handle cover.
• Tighten handle cover bolts to the specified torque.
99000-25161: WATER RESISTANT GREASE
Tiller handle cover bolt: 17 N·m (1.7 kg-m, 12.5 lb-ft)
• Installation of throttle cables. (See page 4-13.)
• Check wire and cable routing. (See page 9-8 to 9-10.)
MID UNIT 7-5