6. On remote control model:
Disconnect the auto-enrichener lead wire connector.
INSTALLATION
Installation is the reverse order of removal with special attention
to the following steps.
Do not re-use gasket, as sealing abilities will be insuf-
ficient. Air leakage will induce a lean air/fuel mix which
will result in severe engine damage.
• On tiller handle model:
Install starter cable with starter plunger 1, then tighten the
starter cable lock nut 2 securely.
• Install insulator gasket 3, insulator 4, carburetor gasket 5,
carburetor 6 and silencer case 7, then tighten carburetor
mounting bolts 8 to specified torque.
Carburetor mounting bolt: 10 N·m (1.0 kg-m, 7.0 lb-ft)
NOTE:
• When installing carburetor gasket, be sure that starter fuel
passage is not obstructed.
• The projection of insulator must be faced to STBD and intake
manifold sides.
FUEL SYSTEM 4-5
1
1. Auto-enrichener