Nortel i2050 User Manual page 9

Installing the i2004 Internet Telephone
The default entry for each parameter will be displayed on the screen (see Figure
4).
NOTE: Some versions of the i2004 begin with the prompt ' SET IP' . You will then
be asked to edit or accept all of the parameter information in Table 1 on page 10.
The last parameter prompt will be ' DHCP?' . In this situation, you should enter 0 –
the set will then display ' Locating server' (see Figure 5 and go to the instructions
that follow it).
Figure 4
On most i2004 sets, you are first prompted to set DHCP parameters.
If the i2004 will use DHCP, enter a 1 on the keypad. You will be asked to
indicate the level of DHCP use; enter 0 for full DHCP (parameters will be set
automatically) or 1 for partial DHCP (parameters will be partially entered). Once
parameters are entered, ' Locating server' will appear on the display (see Figure 5
and go to the instructions that follow it).
If the i2004 will not use DHCP, enter a 0 on the keypad. You will be prompted
to set all necessary parameters manually.
As you enter parameters manually, use the BKSPACE or CLEAR softkeys to
edit the default entry. BkSpace will delete each character as the key is pressed.
Clear will delete the entire entry.
Internet Phone User Guide
Manual Cfg
DHCP? (0-No, 1-Yes)
OK BkSpace Clear Cancel
Nortel Networks
9