Interface Module Leds - HP ProCurve 8100fl Series Installation And Getting Started Manual

Introducing the ProCurve Series 8100fl Switch
Front of the Switch

Interface Module LEDs

Interface modules have LEDs showing activity and link status by port, plus a
Status LED at the bottom showing the operational status of each module. LED
function and behavior differs according to module (refer to the following
tables for details).
Table 1-3.
1-Port 10GB LR Module
Activity and
Link LEDs
LR port
Status LED
N o t e
This module was discontinued in Summer 2006. The 2-Port X2 10Gbe Module
(J8737A) shown on
connectivity (with separate purchase of LR transceivers) in a two port X2,
media-flexible package.
1-8
1-Port 10GB LR Module (J8733A) LEDs
LED Color State
Activity Green Flashing
(Act)
Green Solid
Off Flashing
Link Green Solid
n/a Off
Status n/a Off
Green Flashing
Green Solid
Yellow/ Flashing
Orange
page 1-12, provides functionally-equivalent LR
Meaning
Transmitting data.
Link is up; no data is being transferred.
When no connector is plugged into the
port, the LED will flash approximately
once every few seconds. This on/off cycle
is a safety feature known as Auto Laser
Shutdown.
Link is up.
No connector is plugged into the port.
No power to the module.
Module is powering up and downloading
operating software.
Software image loaded successfully.
Self-test failure.