HP ProCurve 8100fl Series Installation And Getting Started Manual page 86

Replacing Hardware
Replacing Mini-GBICs
To remove a mini-GBIC with a wire bail:
1. Remove the fiber cable from the mini-GBIC.
2. Lower the bail until it is approximately horizontal.
3. Using the bail, pull the mini-GBIC from the slot.
4. If the mini-GBIC is not defective (disposable), protect it by inserting a dust
Installed Position
ProCurve mini-GBIC
Release
ProCurve mini-GBIC
Remove
4-14
plug.
Locking tab releases from socket
ProCurve mini-GBIC
mini-GBIC with
wire bail release
Socket
Bail
Locking tab
1. Pull bail out
to unlatch
2. Remove from socket