HP ProCurve 8100fl Series Installation And Getting Started Manual page 51

1. Lower the power supply
handle to an approximate
45 degree angle.
C a u t i o n
To install an AC power supply (J8732A):
1. Insert a flat blade screwdriver (or similar lever device) into the indent
located on the bottom edge in the center of the handle. Gently turn the
screwdriver with the handle downward and lower the power supply
handle to its fully extended position.
2. Position the power supply between the guides in an open power supply
slot.
AC Power Supply
3. To lock the power supply in place, adjust the
handle position at the edge of the chassis, and then
rotate the handle upwards to engage retaining
3. Slide the AC power supply all the way into the slot, firmly but gently
pressing to make sure that the connectors on the back of the power supply
are completely seated in the backplane.
4. Push the handle up and flush with the power supply chassis. The handle
should snap into place, locking the power supply into position.
If the handle does not snap into a vertical position, do not force it. You
may need to re-insert the power supply, taking care to adjust the handle
position during the final few centimeters to successfully engage the
retaining latch.
Installing the ProCurve Switch 8100fl
Installation Procedures
2. Slide power supply
completely into chassis
2-25