6.
1. Hold upper ejector
lever out to keep in
unlocked position.
C a u t i o n
7.
Tighten the captive screw on each ejector by hand and seat with a screw
driver to keep the module from being removed accidentally. Do not
overtighten the captive screws.
3. Rotate ejectors to
lock the module in
place, and then
tighten the captive
screws.
Switch Fabric Module
Metal Plate
Module Guides
The module must be fully seated and the ejectors fully locked (vertical)
before the captive screws will align properly. Also, fully seating the
module ensures proper contact of the card with the backplane which is
necessary for optimal performance.
Repeat steps 1 to 6 to install a second switch fabric module to provide full
(100%) redundancy in the event of a failure of the primary module.
Installing the ProCurve Switch 8100fl
Installation Procedures
2. Install switch
fabric modules in
two center slots.
2-19