HP ProCurve 8100fl Series Installation And Getting Started Manual page 36

Installing the ProCurve Switch 8100fl
Installation Procedures
To mount the ProCurve Switch 8100fl chassis:
1. Lift the chassis out of the shipping container with the help of the product
2. Remove all module and power supply blanks from the chassis to make it
3. Move the chassis into position in front of the rack using a trolley (not
4. (Optional) Install a rack shelf (not provided with your switch) into
W A R N I N G
2-10
sling (shown on page 2-12) packed with the chassis.
as light as possible before installing it in the rack.
shipped with the switch).
Position the chassis so that the front of the switch is facing towards you.
This will allow you to easily slide the chassis into place.
position as low as possible in the rack. Make sure that any screws used
to secure the shelf to the rack are securely tightened.
Rack Shelf (Optional)
Make sure the rack is bolted down to prevent it from becoming
unstable and/or falling over when the chassis is installed.
The chassis will be installed on top of the rack shelf.