HP ProCurve 8100fl Series Installation And Getting Started Manual page 21

Table 1-6.
1-Port X2 10GbE Module
Link and
Activity LEDs
Transceiver
slot cover
Status LED
N o t e
This module's discontinuance is in Spring 2007. The 2-Port X2 10Gbe Module
(J8737A) shown on
media-flexible connectivity in a two port package.
1-Port X2 10GbE Module (J8736A) LEDs
LED Color State
Link Green Solid
Orange Flashing
n/a Off
Activity Green Flashing
(Act)
Green Solid
n/a Off
Link and Orange/ Solid Orange (0.5
Activity Green/ secs), then Solid
(both port Off Green (1.5 secs),
LEDs and then Off
together)
Link, Activity Orange/ Solid Orange (0.5
and Status Green/ secs), then Solid
(all module Off Green (1.5 secs),
LEDs and then Off
together)
Status n/a Off
Green Flashing
Green Solid
Amber Flashing
page 1-12, provides functionally-equivalent X2
Introducing the ProCurve Series 8100fl Switch
Front of the Switch
Meaning
Link is up
Self-test failure or unsupported
transceiver. See Error Log for
details.
No connector is plugged into the
port.
Transmitting data. Blink rate
indicates traffic utilization of the
port.
Traffic exceeds 90% of link
capacity.
No connector is plugged into the
port, or no traffic is being passed
through the port.
A transceiver has been correctly
inserted into the transceiver port.
After the insertion test, the LEDs
will remain Off until a network
cable is inserted into the
transceiver and the LEDs follow
their normal operational behavior.
The module is receiving initial
power due to being inserted into
the slot, and/or due to the slot being
enabled via the CLI.
No power to the module.
Module is powering up and
downloading operating software.
Software image loaded
successfully.
Self-test failure.
1-11