Wireless Security; Trusted Stations; Ethernet (Wan) Port Configuration - Planet WAP-4050 Manual Manual

DMZ PC
Wireless LAN
AP/Router IP
Address
Subnet Mask
Enable DHCP
Server for
Wireless clients

3.2.2 Wireless Security

It is the same as the configurations in AP mode, please refer to section 3.1.2.

3.2.3 Trusted Stations

It is the same as the configurations in AP mode, please refer to section 3.1.3.

3.2.4 Ethernet (WAN) Port Configuration

This screen can be accessed by clicking the Configure button in AP/Router Setup page.
Travel Mode (Hotel)
The Ethernet Port Configuration is set to Travel mode (Hotel) by default.
The DMZ PC will receive all incoming traffic for which the correct
destination PC is unknown.
·
This field shows the current DMZ PC.
·
The default value is "None", meaning the DMZ feature is
disabled.
The IP address of the WAP-4050 on the Wireless LAN.
·
The default value is 192.168.0.1
·
If you wish to change any settings while in AP/Router mode,
you must connect to the WAP-4050 using this IP address.
·
Normally, it is not necessary to change this IP address.
·
You MUST change this address if the LAN/WAN on the
Ethernet (WAN) port is using the same IP address range
(192.168.0.1 ~ 192.168.0.254).
The recommended value to change to is 192.168.1.1
Note: In AP/Router mode, the WAP-4050 has 2 IP addresses, one
for the Wireless interface, and another for the Ethernet (WAN) port.
The subnet mask for the IP address above.
The default value is 255.255.255.0, which is the standard value for
small networks.
The DHCP Server will provide an IP address and related information
to Wireless clients when they connect to the WAP-4050.
·
The default value is Enabled. It is strongly recommended that
this feature be enabled.
- 23 -