Planet WAP-4050 Manual Manual page 31

Network Mask
PPPoE Link Status
Connection Log
Connection Log
Buttons
Connect
Disconnect
Clear Log
Refresh
Message
Connect on Demand
Manual connection
Reset physical
connection
Connecting to remote
server
Remote Server located
Start PPP
PPP up successfully
Port interface. If using DHCP, and there is no current connection,
this will be blank or 0.0.0.0.
The Network Mask associated with the IP Address above.
This indicates whether or not the connection is currently
established.
·
If the connection does not exist, the Connect button can be
used to establish a connection.
·
If the connection currently exists, the Disconnect button can
be used to break the connection.
·
The Connection Log shows status messages relating to the
existing connection.
·
The most common messages are listed in the table below.
·
The Clear Log button will restart the Log, while the Refresh
button will update the messages shown on screen.
If not connected, establish a connection to your ISP.
If connected to your ISP, hang up the connection.
Delete all data currently in the Log. This will make it easier to
read new messages.
Update the data on screen.
CONNECTION LOG MESSAGES
Description
Connection attempt has been triggered by the "Connect
automatically, as required" setting.
Connection attempt started by the "Connect" button.
Preparing line for connection attempt.
Attempting to connect to the ISP's server.
ISP's Server has responded to connection attempt.
Attempting to login to ISP's Server and establish a PPP
connection.
Able to login to ISP's Server and establish a PPP connection.
- 31 -