Planet WAP-4050 Manual Manual page 22

Allow trusted This feature can be used to prevent unknown Wireless stations from
stations only using the WAP-4050. To use this feature:
·
·
Warning: Ensure your own PC is in the Trusted Stations list before
you enable this feature.
Copy AP Mode
Clicking this button will copy the Wireless settings, including the
Settings
Trusted Station list, from the AP mode to AP/Router mode.
·
·
Ethernet (WAN) Port
IP address
The current IP address for the Ethernet port. This will be blank if:
·
·
Note: In AP/Router mode, the WAP-4050 has 2 IP addresses, one
for the Wireless interface, and another for the Ethernet (WAN) port.
MAC Address
The MAC address, also called the Physical address, is a low-level
identifier for Ethernet connections. This field displays the MAC
address for the Ethernet (WAN) port.
Connection
The login method is the type of connection used on the Ethernet
Type
(WAN) port.
·
·
Connection
This indicates the current status of the connection on the Ethernet
Status
(WAN) port.
This can only show Connected if the WAP-4050 is in AP/Router
mode.
Select the checkbox.
Click the Trusted Stations button to open a sub-window
containing the Trusted Wireless Stations screen, where you
can enter details of the Trusted Wireless Stations. See the
following section for further details.
This is only useful if you already completed the configurations of
AP mode.
The SSID will not be copied. Each mode must use a different
SSID. Using the same SSID for different modes would confuse
wireless clients.
The WAP-4050 is not in AP/Router mode.
The WAP-4050 is in AP/Router mode, but there is no active
connection on the Ethernet (WAN) port.
The default value is Travel Mode (Hotel). This mode requires
no additional information to be input.
To change the Login method, click the Configure button.
- 22 -