Planet WAP-4050 Manual Manual page 33

IP Address
PPTP Status
Connection Log
Connection Log
Buttons
Connect
Disconnect
Clear Log
Refresh
L2TP
If using L2TP, a screen like the following example will be displayed when the Status button is clicked.
The IP Address of this device, as seen from the Ethernet (WAN)
Port interface. If using DHCP, and there is no current connection,
this will be blank or 0.0.0.0.
This indicates whether or not the connection is currently
established.
·
If the connection does not exist, the Connect button can be
used to establish a connection.
·
If the connection currently exists, the Disconnect button can
be used to break the connection.
·
The Connection Log shows status messages relating to the
existing connection.
·
The Clear Log button will restart the Log, while the Refresh
button will update the messages shown on screen.
If not connected, establish a connection to your ISP.
If connected to your ISP, hang up the connection.
Delete all data currently in the Log. This will make it easier to read
new messages.
Update the data on screen.
- 33 -