Redialing When the Line Is Busy
If the other party's line is busy or there is no answer, the machine waits two minutes, then tries
to dial the same number again. This feature is called "Automatic Redialing."
What Is Automatic Redialing?
After the initial dialing attempt, the machine waits two minutes, and tries to dial again. If the
second attempt fails, the machine waits for two more minutes, and makes a third and final
attempt to complete the call.
Auto Redial can be turned 'ON' and 'OFF'. To perform this procedure, see "Setting Up
Redialing", on p. 3-22.
The number of redialing attempts and the time interval between attempts can also be set with
the Auto Redial feature.
Messages Displayed When Redialing
While the machine is waiting to redial when using Direct TX, the following message is
displayed:
If all redialing attempts fail, the machine cancels the transaction, displays the following
message, and prints an Error TX report to remind you that the transmission did not
complete.
NOTE
• To cancel redialing, if you are using Direct Sending, press
Sending, press [Delete File].
• To erase the document from memory, press [Delete File]. (See "Erasing a Document from Memory",
on p. 9-22.)
AUTO REDIAL
TX/RX NO.
DIRECT SENDING NG
PRESS OK KEY
0019
(Stop). If you are using Memory
Redialing When the Line Is Busy
3
3-21