Canon FAX-L2000 Facsimile Manual page 77

If you are using Direct Sending, you will see a series of brief, alternating
messages that tell you the machine is dialing, calling then transmitting the
document. The number being dialed, name of the other party, and transaction
number of the document are also displayed.
TRANSMIT
SCANNING
NOTE
• To start scanning immediately, press
seconds before it starts to scan. This timeout feature can be turned 'OFF'. (See "TX
(Send) Settings", on p. 11-13.)
• The machine does not dial the number registered for the one-touch speed dialing key
until you place your documents for sending. If you press the one-touch speed dialing key
before you place your documents, the machine prompts you to set your documents.
SET DOCUMENT
• If you press a one-touch speed dialing key where no number has been registered, the
machine displays:
NOT REGISTERED
07
• If you register a number for one-touch speed dialing, you can, as an option, set the time
you want your document to go out (up to five different sending times in a day). (See
"Setting Up One-Touch Speed Dialing", on p. 2-9.)
• If you want to send your document at a preset time using one-touch speed dialing, make
sure that no other preset time has been set by someone else for the one-touch speed
dialing key. (See "Setting Up One-Touch Speed Dialing", on p. 2-9.)
• If you want to cancel the transmission after you press a one-touch speed dialing key,
press (Stop).
0003
P.001
(Start). Otherwise, the machine waits five
Using Speed Dialing
2
2-35