10G4Ca I/O Module; Blackdiamond 8800 C-Series I/O Modules - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

10G4Ca I/O Module

The 10G4Ca I/O module
connectors.
Figure 22: 10G4Ca I/O Module
10GBASE-CX4
Module status LEDs
In the default configuration of the 10G4Ca I/O module, all ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●
The 10G4Ca I/O module has the following LEDs:
Module status
●
Module diagnostics
●
Port status
●
For information about the LEDs and their activity on the 10G4Ca I/O module, see
on page 53.

BlackDiamond 8800 c-Series I/O Modules

The BlackDiamond 8800 c-series of I/O modules consists of the following:
G48Tc I/O Module on page 40
●
10G4Xc I/O Module on page 41
●
10G8Xc I/O Module on page 42
●
G24Xc I/O Module on page 43
●
G48Xc I/O Module on page 44
●
CAUTION
ExtremeXOS builds earlier than version 12.1 do not support the BlackDiamond 8800 c-series modules. If
you attempt to install one of these I/O modules before upgrading the software on your MSM the module will not be
recognized by the software and it will not power up. The following error messages are similar to the messages that
may be displayed on the console or in the log. (Samples represent an unrecognized module in slot 2.)
Console: ERROR: Unknown cardtype in slot 2 - please program the eeprom
●
Log: <Error: HAL.Card.Error> MSM-A: Unable to read cardtype for slot 2
●
BlackDiamond 8800 Series Switches Hardware Installation Guide
(Figure 21) has four 10-gigabit Ethernet ports that use CX4 interface
10 Gbs ports
10G4Ca 10G4Ca 41613
BD_156
"I/O Module LEDs"
39