Blackdiamond 8800 E-Series I/O Modules; G48Te I/O Module - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

BlackDiamond 8800 e-Series I/O Modules

The BlackDiamond 8800 e-series of I/O modules include:
G48Te I/O Module on page 45
●
G48Pe I/O Module on page 46
●
G48Te2 I/O Module on page 47
●
CAUTION
ExtremeXOS software builds earlier than version 11.5.0 do not support G48Te or G48Pe I/O modules.
ExtremeXOS builds earlier than version 12.1 do not support the G48Te2 I/O module. If you attempt to install one of
these I/O modules before upgrading the software on your MSM to the required minimum version, the module will
not be recognized by the software and it will not power up. The following error messages are similar to the
messages that may be displayed on the console or in the log. (Samples represent an unrecognized module in slot
2.)
Console: ERROR: Unknown cardtype in slot 2 - please program the eeprom
●
Log: <Error: HAL.Card.Error> MSM-A: Unable to read cardtype for slot 2
●

G48Te I/O Module

The G48Te I/O module
RJ-45 connectors. When an 8800 series switch is running in dual-MSM mode, this module will be
oversubscribed 2:1. When the switch is running a single MSM, this module will be oversubscribed 4:1.
Figure 28: G48Te I/O Module
Module status LEDs
In the default configuration of the G48Te I/O module, all ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●
Operate in autonegotiation mode
●
The G48Te I/O module has the following LEDs:
Module status
●
Module diagnostics
●
Port status
●
For information about the LEDs and their activity on the G48Te I/O module, see
on page 53.
BlackDiamond 8800 Series Switches Hardware Installation Guide
(Figure 28) has 48 autosensing 10/100/1000BASE-T ports that use standard
10/100/1000BASE-T
ports
ASP047
"I/O Module LEDs"
45