Removing The Psu/Fan Controller - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

Removing the PSU/Fan Controller

To remove a PSU/fan controller from the BlackDiamond 8800 series switch:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the top left corner of the switch front panel.
2 Locate the eight captive screws on the PSU/fan controller access cover at the back of the switch (see
Figure 119 and Figure
Figure 119: Removing the Access Cover from the BlackDiamond 8810 Switch
BlackDiamond 8800 Series Switches Hardware Installation Guide
120).
Loosen Captive
Screws (x8)
PSU Control
Card Access Panel
Remove PSU
Control Card
Access Panel
Cover
ASP032B
161