Chapter 12: Replacing Blackdiamond 8800 Series Chassis Components; Replacing The Fan Tray; Pre-Installation Requirements - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

12
C H A P T E R
This chapter provides instructions for replacing components in the BlackDiamond 8800 series switches
and includes the following sections:
Replacing the Fan Tray on page 157
●
Replacing the PSU/Fan Controller on page 160
●
This chapter describes how to remove and replace a fan tray or a PSU/fan controller in the following
BlackDiamond switches:
BlackDiamond 8810 switch
●
BlackDiamond 8806 switch
●

Replacing the Fan Tray

The BlackDiamond 8800 series switch has one fan tray that is accessible from the front of the switch.
NOTE
To avoid long periods of operation without forced air cooling, make sure you have the replacement fan tray
ready before you start the replacement procedure.

Pre-Installation Requirements

You need the following tools and equipment to remove and replace a fan tray in a BlackDiamond 8800
series switch:
#2 Phillips screwdriver
●
Replacement BlackDiamond 8800 series fan tray
●
BlackDiamond 8800 Series Switches Hardware Installation Guide
Replacing BlackDiamond 8800
Series Chassis Components
157