Panasonic KX-TDA30 Installation Manual page 229

3.
Plug the AC cord into the AC adaptor, and then plug the other end into an AC outlet.
AC Adaptor
To AC outlet
4.
Turn on the power switch. The RUN indicator will flash.
Power Switch
Note
•
For safety reasons, follow the procedures as indicated when turning on the PBX.
•
For safety reasons, do not stretch, bend, or pinch the AC cord and the DC cable of the AC adaptor.
5.
While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position.
Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared, and the PBX as well as all optional service cards (except for the IP-GW4 card) will be
initialised to the default values. The DPTs should show the time as 01:00. The data of the IP-GW4 card will
not be initialised.
IMPORTANT
Use only the AC adaptor (Panasonic PSLP1244/Panasonic PSLP1434) and AC cord supplied with
the PBX, or the Additional AC Adaptor (KX-A236).
AC Cord
2.13.1 Starting the PBX
Installation Manual 229