Panasonic KX-TDA30 Installation Manual page 179

Mounting the KX-TDA0141
WARNING
•
Make sure that the wall that the unit will be attached to is strong enough to support the unit
(approx. 310 g). If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment (screws, washers) included with the unit.
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths
or metal plates in the wall.
•
When this product is no longer in use, make sure to detach it from the wall.
1.
Place the reference for wall mounting (KX-TDA0141) on the wall to mark the 2 screw positions.
2.
Install the 2 screws and washers (included) into the wall.
Note
•
Make sure that the screw heads are at the same distance from the wall.
•
Install the screws perpendicular to the wall.
3.
Hook the CS on the screw heads.
CAUTION
Make sure the cables are securely fastened to the wall.
Washer
Drive the screw
to this point.
2.8.8 Wall Mounting
Installation Manual 179