Panasonic KX-TDA30 Installation Manual page 205

Entering the System Programming Mode
PT (Administrator Level)
#
PROGRAM/
PAUSE
Note
means default value throughout this section.
Setting the Personal Identification Number (PIN) for PS Registration
To prevent registering the PS to a wrong PBX, a PIN for PS registration can be set to the PBX. Before registering
the PS to the PBX, enter the PIN set to the PBX into the PS. By doing so, the PS will only be registered to the
PBX with the matching PIN.
Note
•
By default, the PIN for PS registration is "1234" for both the PBX and PS. Therefore, the PS can be
registered to the PBX without setting the PIN.
•
The PIN for PS registration will only be used when registering the PS to the PBX. Therefore, during
normal operation after registration, even if there is more than 1 PBX with the same PIN near the PS,
the PS will not be inadvertently linked to a different PBX.
Setting the PIN for PBX
[692]
ENTER
Setting the PIN for PS
Using the KX-TD7685/KX-TD7695
Press POWER
for 2 seconds.
If required
System Lock Password
4 digits
PIN for PS Registration
1 to 8 digits
1234
PS Registration
[690]
ENTER
System Password for Administrator—
for PT Programming
= 1234
PIN for PS Registration
4 digits
1234
Select
"Setting Handset".
Select
"Change PIN".
C.Tone
PS No. Extn. No.
001 to 028 1 to 4 digits
2.9.7 Connecting a Cell Station to the PBX
Programming No.
3 digits
END
ENTER (HOLD)
Select
"System Option".
To the PS
operation
below
ENTER
END
(HOLD)
Installation Manual 205