Toshiba e-studio16 Operator's Manual page 232

Error Message Displayed
Job Separator Upper Tray Paper Full
Job Separator Lower Tray Paper Full
Toner Empty
Change Drum
No Process Unit
Data Transfer Error on Network
Examine Stapler
Job too Complex
Memory Overflow
Drum Life Out
Toner Low
Illegal Paper Size
Load [paper size] in Cassette1
Load [paper size] in Cassette2
Load [paper size] in Cassette3
Load [paper size] in Cassette4
Load [paper size] in SFB
Load [paper size] in LCF
Load [paper size]
Data Existing
Initializing
Power Saving
Processing
Warming
Canceling Job
Printer Ready
Printing
Use By Another Job
Downloading Code
Printer Power Off or Communication Error
230
Action
Remove the paper from the Job Separator Upper Tray.
Remove the paper from the Job Separator Lower Tray.
Please change the Toner.
Replace the Process Unit.
Set the Process Unit.
Transfer again.
Examine Stapler.
1. Print the data with lower resolution.
2. Simplify the job.
3. Add the optional memory.
1. Simplify the job.
2. Add the optional memory.
Prepare a new drum cartridge.
Prepare a new toner cartridge.
Change the Paper size.
Load [paper size] size paper in Cassette 1.
Load [paper size] size paper in Cassette 2.
Load [paper size] size paper in Cassette 3.
Load [paper size] size paper in Cassette 4.
Load [paper size] size paper in SFB.
Load [paper size] size paper in LCF.
Load [paper size] in any cassette.
Select the form feed on front panel or wait for a
while.
Wait for a while.
Wait for a while.
Wait for a while.
Wait for a while.
Don't Power Off before complete. Please wait for
a while.
1. Power on the printer.
2. Check if the cable is connected properly.
-
-
-
-