Toshiba e-studio16 Operator's Manual page 23
For printer function print kit
Hide thumbs
Also See for e-studio16:
- Administrator's manual (134 pages) ,
- Operator's manual (126 pages) ,
- Specification sheet (14 pages)
Table of Contents
Advertisement
7
Check on Enable TCP/IP and enter the
IP Address.
G Enter the Subnet Mask and Default Gateway
address if necessary.
G Go to step 9.
8
Check off IP Address in NVRAM.
G "Enable DHCP" should be checked as a default
setting. Ensure that it is enabled.
SUPPLEMENTS:
G When the "IP Address in NVRAM" option is enabled, the IP address that was previously
obtained from the DHCP is stored in NVRAM. The NIC uses the IP address stored in
NVRAM the next time the printer is powered on, instead of obtaining an IP address from
the DHCP server. In order to avoid any network address conflicts, it is recommended
that you do not use the "IP Address in NVRAM" option when using the "Enable DHCP"
option.
G If there is a WINS server and you want to use a WINS name for the NIC, enter the
NetBIOS Name and the IP address of the Primary NetBIOS Name Server. When using
a DHCP server to obtain an IP address, TCP/IP printing cannot be performed because
the IP address changes each time the printer is powered on. By configuring the port with
a WINS name instead of an IP address, TCP/IP printing can be performed.
21
Advertisement
Table of Contents
