Toshiba e-studio16 Operator's Manual page 175

➁
[Printer Configure]
Click this to configure the local system properties, such as system location, input tray, output bin, paper, and system
settings, for the selected printer.
After you modify the printer configuration, you must reset the printer to enable the settings.
[Refresh Status]
Click on this to update the status. This button is not
available when the Refresh Rate is set at the WNP Setting
on the NetPanel Setting.
➂
[NIC Configure]
Click on this to configure the NIC settings, such as enabled protocols, IP address, frame type and serial number of
the NIC.
After you modify the NIC configuration, you must reset the printer to enable the settings.
[Refresh Status]
Click on this to update the status. This button is not
available when the Refresh Rate is set at the WNP Setting
on the NetPanel Setting.
General Properties
Configure the system location and contact.
Input Tray Properties
Select the default input tray.
Output Bin Properties
Select the default output bin and options.
Paper Properties
Set the default paper settings such as number of
copies, default paper size, and duplex mode.
Printer Setting Properties
Set the default printing methods.
PCL Font Properties
Set the PCL settings such as orientation and PCL
Font.
Group Management
Reset the group counter.
Protocols Configuration
Select to enable or disable TCP/IP, IPX/SPX, and
AppleTalk.
IP Configuration
Assign the IP Address, Subnet Mask, and Default
Gateway.
Apple Talk Configuration
Set the printer name and the zone for AppleTalk.
System Configuration
Select the frame type and enter the Serial
Number of the NIC.
173