Table of Contents
Advertisement
Installation
Surround Panel & Control Panel Installation & Removal
NOTE: Attach the vent prior to installing the surround panels (and circuit board).
1. Position the insert so the front of insert is approximately 14" to 16" from the fireplace
opening.
2. The control panel is shipped inside a box, attached to the top of the insert. Remove it
from the box and place it near the insert.
3. On older models the side panels are shipped attached (on newer models the panels are
ordered separately – skip to step 5).. Each side panel is held in place with two screws
(see photo below, to the left). Use a phillips screwdriver to loosen these screws 2 turns.
2 Screws
Hold Side
Panel in
Place
© Travis Industries
(For Qualified Installers Only)
4141230
19
2 Turns
100-01341
Advertisement
Table of Contents
