Surround Panel Installation - Travis Industries DVS User Manual

I
Installation Without Surround Panels
The insert may be installed without surround panels if a 3/8"
(10 mm) gap is allowed between the sides and top of the face
and the fireplace (for ventiliation). Wire mesh screen may be
placed over this gap.
Min. 3/8"
(10 mm)

Surround Panel Installation

PANEL SIZE
8" x 10"
10" x 13"
1 Follow the
instructions
to the right
for
installing
the side
panels.
2 Follow the
instructions
to the right
for
installing
the top
panel,
insulation,
and trim.
I
NSERT NSTALLATION
a
Disconnect the on/off switch from
b
the red and brown wires. Insert
the switch into the hole until it
locks in place. Re-attach the red
and brown wires (orientation does
not matter).
WIDTH
40-3/8"
44-3/8"
b
Line up each side surround
panel and insert two screws from
the outside to secure in place.
a
Install the top panel so
the two tabs insert into
the slots on the side
panels.
(C .)
ONT
Face Size:
Discovery & Rosario (Avanti)
FPX 32 DVS
Heritage Bay
Salish Bay
Cambridge
Use a knife to cut out the on/off switch hole
(the label covers a square hole in the bracket).
Keep the jumper wire in
place while installing.
HEIGHT
28-7/8"
31-7/8"
a
Tuck the included insulation between
Top Trim
the top panel and the facing (not
b
along the sides). Cut off excess
insulation.
Top
Panel
- For Qualified Installers Only!
Width Height
32"
21-5/8"
30"
22"
31-5/8" 21-1/2"
30-1/2"
22-1/2"
33-7/8" 21-1/2"
PART #
98500610
98500611
Pre-thread the holes on the panel mounting
brackets with the screws included in the
surround panel kit (both sides).
5/16" Nutdriver
Run the wires from
the on/off switch and
the power cord
behind the surround
panel (cut the lock-
tie holding the on/off
switch in place).
NOTE:
You may need to
pull the insert out
slightly while
installing the side
surround panels -
do not damage the
gas line or vents.
Tighten the set
c
screws from the
back side with a
small standard
screwdriver
Top Trim
"L" Bracket
Right Side
Trim
"L" Bracket
Construct the panel trim.
Insert one leg of each "L"
bracket into the top and side
trim piece. Align the trim to
form a precise corner, then
tighten the two set screws
Right Side Trim
with a small standard
screwdriver. Slide the trim
over the panels. Attach a
piece of included double-
Double-Back
back tape to the bottom of
Tape
each side trim to keep it from
flaring at the bottom.
P 11
AGE
c
Use a lock tie or
other device to
bundle the
excess wire.
Then tuck it
below the piezo
igniter to keep it
from coming in
contact with the
burner pan.