Surround Panel Installation; Face Installation - Travis Industries Large Flush Owner's Manual

Fireplace Insert Installation

Surround Panel Installation

Standard Size
1. Before installing, the insert should be in place with the flue attached. Attach the brackets as
shown below, using the screws included in the hardware pack with the insert. Make sure the
brackets are flush with the front of the convection chamber.
2. Attach the surround panel as shown below.
HINT:

Face Installation

There are several face options available for this fireplace insert. Refer to the instructions included with
your face.
© Travis Industries
Width
1067 mm
When installing the panel, route the wires through the notch on the bottom of
the panel (either side).
(for qualified installers only)
Height
826 mm
100-01291
96100392
13
Part#
4060512