Surround Panel And Face Installation - Travis Industries Flush Plus Owner's Manual

12 Fireplace Insert Installation

Surround Panel and Face Installation

The surround panel and face should be installed in the following order. Detailed installation instructions
are included in the surround panel and face installation instructions.
1. With the insert in place, and flue connected, attach the surround panel brackets.
2. Slide the surround panel into place, making sure the four pins hold it into place. NOTE: While
installing, route the power cord to the side of the panel, out the slot (if using a wiring kit, disregard
this step).
3. Remove the air control and bypass handles.
4. Place the face near the fireplace. Attach the rheostat wires (and power wires, if applicable).
Tuck all excess wire under the fireplace, away from hot or moving components.
5. Attach the face to the surround panels.
© Travis Industries
(for qualified installers only)
100-01261 4110328