Twain Lock Time - Konica Minolta bizhub C451 Network Scanner Operations

Specifying utility mode parameters

TWAIN lock time

Specify the length of time until the machine's operations are unlocked during scanning (except with PUSH
scanning). (The default setting is 120 seconds.)
1
Touch [4 Scan/Fax Settings].
– For details on displaying the User Settings screen, refer to "Displaying the user settings screen" on
page 4-5.
2
Touch [TWAIN Lock Time].
3
Press the [C] (clear) key to erase the value, and then use the keypad to specify the desired length of
time (between 30 and 300 seconds).
– If a value outside the allowable range is specified, the message "Input error" appears. Type a value
within the allowable range.
4
Touch [OK].
The TWAIN lock time is set.
Note
To finish specifying settings in the Utility mode, press the [Utility/Counter] key. Otherwise, exit the Utility
mode by touching [Close] in each screen until the screen for the Copy, Fax/Scan or Box mode appears.
If Konica Minolta TWAIN is being used, it is automatically unlocked at the specified time, even if it was
locked from the computer.
If optional image controller IC-409 has been installed this parameter is not available.
bizhub C451/C550/C650
4
4-37