Ftp - Konica Minolta bizhub C451 Network Scanner Operations

4
16
Touch [File Path], and then type in the file path, using the keyboard that appears.
– To check the contents of the shared folders, touch [Reference].
17
Touch [OK], and then touch [OK] in the next screen that appears.
The SMB destination is registered.
!
Detail
To check a registered destination, select it, and then touch [Check Job Set.].
To change the settings for a registered destination, select it, and then touch [Edit]. The registration
number cannot be changed in the Edit screen.
To delete a registered destination, select it, and then touch [Delete].
If the computers or workgroups on the network (subnet) that this machine belongs to is more than the
numbers listed below, browsing over the network may not be performed correctly.
Workgroups: 128
Computers: 128
Note
The registration cannot be completed if no settings are specified for "Name", "Host Address" and "File
Path".
To cancel the registration, touch [Cancel].
To finish specifying settings in the Utility mode, press the [Utility/Counter] key. Otherwise, exit the Utility
mode by touching [Close] in each screen until the screen for the Copy, Fax/Scan or Box mode appears.

FTP

Settings can be specified for the following for the FTP destination to be registered.
Parameter
No.
Name
Index
Host Address
File Path
User ID
Password
anonymous
PASV
Proxy
Port Number
4-14
Description
Type in the registration number (between 1 and 2000) for the address book destination. When
the screen appears, the displayed number is the lowest available number.
Type in a name of 24 characters or less for the registered destination.
Select the index characters. For frequently used destinations, touch [Favorites] so that the des-
tination can be found more easily.
Type in the host address in the format of a host name, IPv4 address or IPv6 address.
For a host name, type in 63 characters or less.
Type in 96 characters or less for the path to the saved file.
Type in 47 characters or less for the user ID for logging onto the host computer.
Type in 31 characters or less for the password for logging onto the host computer.
To specify no user ID for logging onto the host computer, touch [ON].
Select whether or not the PASV mode is used.
Select whether or not a proxy server is used.
Type in the port number. (Range: 1 to )
Specifying utility mode parameters
bizhub C451/C550/C650