Konica Minolta bizhub C200 Network Administration Manual page 23

Specifying network settings
7
Use the keypad to type in the subnet mask value, and then touch [OK].
– To enter a number with less than 3 digits, touch
8
Touch [Gateway].
9
Use the keypad to type in the gateway address, and then touch [OK].
– The IP address cannot be specified to begin with "0.", "127.", or a number greater than "224".
– To enter a number with less than 3 digits, touch
10
Touch [Network Board Set].
11
Select the transmission speed and duplex setting for the network board, and then touch [OK].
– Normally, "Auto" is selected. Select the transmission speed and duplex setting only if transmission
is not performed normally with "Auto" selected. If the transmission speed and duplex setting are not
correctly selected, transmission is not possible, or there is a reduction in communication
performance.
bizhub C200
to move the cursor to the next number.
to move the cursor to the next number.
2
2-9