PIAGGIO Beverly 500 i.e. Workshop Manual page 262

Suspensions
001467Y034 Pliers to extract ø 15-mm bearings
001467Y014 Calliper to extract ø 15-mm bear-
ings
001467Y009 Driver for OD 42-mm bearings
•
Support the front wheel with two wood-
en pegs that prevents scratching in
case of contact with the rim.
•
Insert the punch (consisting of adaptor
handle, 15 mm adaptor and guide) on
the odometer movement sensor side to
facilitate removing the left side bearing
and the spacer bushing.
Specific tooling
020376Y Adaptor handle
020456Y Ø 24 mm adaptor
020412Y 15-mm guide
•
Heat the seat of the bearing on the left
side with the heat gun.
•
Fit the bearing using the punch con-
sisting of adaptor handle, 42x47 mm
adaptor and 15 mm guide, and drive it
until it stops.
SUSP - 262
Beverly 500 i.e.