PIAGGIO Beverly 500 i.e. Workshop Manual page 281

Beverly 500 i.e.
•
Apply the buffer and the washer to the
tie rod and lock it.
Locking torques (N*m)
Upper tie mounting:
33-41 Nm
•
Lubricate the shaped washer and
place it onto the bearing.
•
Insert the chassis mounting pin.
•
Restore the axial clearance between
swinging arm and chassis tightening
the pin to the prescribed torque.
•
Tighten the lock nut to the prescribed
torque.
Locking torques (N*m)
bolt securing swinging arm to chassis
Lock nut
40 ÷ 50
•
Tighten the right end of the chassis
connecting pin to the prescribed tor-
que, using a new nut.
Locking torques (N*m)
RHS chassis pin nut
•
Use a 19-mm fork wrench to prevent
the rotation of the pin connecting the
swinging arm to the engine and tighten
the right nut (with washer) and the left
nut to the prescribed torque.
Locking torques (N*m)
Transmission-side nut
nut
56 ÷ 70
14 ÷ 17
66 ÷ 73
Muffler-side
100 - 120
Suspensions
SUSP - 281