PIAGGIO Beverly 500 i.e. Workshop Manual page 97

Beverly 500 i.e.
Engine
- Insert the nut again so as to slightly uncover the
shaft and free the space that was occupied by the
washer.
CAUTION
THIS OPERATION IS REQUIRED AS THE FLYWHEEL IS
STRONGLY LOCKED; THE CONE DETACHMENT MAY
THEREFORE CAUSE THE ROTOR SLIPPAGE, WITH THE
CONSEQUENT BREAKAGE OF THE MAGNETS.
- Insert the special removing tool.
- Using a 27-mm wrench and a 19-mm bushing,
release the flywheel.
Specific tooling
020467Y Flywheel extractor
- Remove the extractor.
- Remove the nut and extract the flywheel with the
start-up rim.
- Remove the crankshaft key.
- To remove the start-up rim from the freewheel it
is necessary to turn it clockwise and pull it out.
ENG - 97