PIAGGIO Beverly 500 i.e. Workshop Manual page 184

Injection
8 - Decoder with proper continuous power supply.
Use the special tool to check the control unit con-
tinuous power supply. Switch set to "ON", switch
to "RUN" and side stand raised.
Pin 26 = battery positive
Pin 23 = battery negative
YES go to 9 NO go to 10
Specific tooling
020481Y Control unit interface wiring
9 - Control unit with proper continuous power sup-
ply.
10 - If only one component is not powered check
the relevant connector. If the problem involves
both the decoder and CPU check the continuity of
the decoder CPU power supply line.
Pin 26 electronic control unit - Pin 87 engine stop
remote control switch = continuity
Pin 8 decoder - Pin 87 engine stop remote control
switch = continuity
YES go to 12 NO go to 11
11 - Fix the cable harness or the connection
YES go to 10
12 - Proper continuous power supply
YES go to 13
13 - Check the connector and the continuity of the
key switch set to "ON"
Pin 1 - 2 = continuity
YES go to 14
14 - Check the engine stop remote control switch
connector and the switch efficiency.
The connector can be recognised by its larger sec-
tion white lead.
85 - 86 = approx. 70W
YES go to 15
N.B.
CHECK THE COIL RESISTANCE
15 - Check the signal circuit:
INJEC - 184
Beverly 500 i.e.