Table of Contents
Advertisement
Flush Wall Mount
Flush Wall Mount
When you are mounting the WLAN Access Port (2230/2231) against a wall (flat side toward the inside of the building), use an
optional factory-orderable flush-mount bracket.
•
Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom of the WLAN
Access Port (2230/2231). Make sure the spring washers have their convex (high center sections) pointing toward the
screw heads.
Note:
The WLAN Access Port (2230/2231) threaded holes have precision-depth threads. Do not overtighten the
screws, or the bracket will not fit under the screw heads.
Figure -
Assembling the Mounting Screws and Spring Washers to the WLAN Access Port (2230/2231)
•
Copy the MAC address(es) from the label(s) on the WLAN Access Port (2230/2231) onto the corresponding location on
the map. MAC addresses have the format 000B85xxxxxx.
•
You have already attached the flush-mount bracket to the wall in
•
Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure.
Note:
Make sure the side of the WLAN Access Port (2230/2231) with the door is facing away from the wall. This
ensures that the correct antenna is facing the building, and makes future upgrades easier.
May 2004
Step 4: Mounting the WLAN Access Ports (2230/2231)
Step 3: Preparing Mounting
Locations.
17
Advertisement
Table of Contents
