Nortel 2230l 2231 Quick Install Manual page 15

Note:
When the Nortel Networks WLAN - Access Port (2230/2231) is powered up and is associated with an Nortel
Networks WLAN - Security Switch (2270) (Green/Power and Yellow/802.11b/g and/or Yellow or Amber/802.11a
LEDs lit), the Nortel Networks WLAN - Access Port (2230/2231) is broadcasting its beacon signal(s). When this
happens, complete the installation as quickly as possible to remove yourself from within 8 inches (20 cm) of the
WLAN Access Port (2230/2231) to comply with FCC RF radiation exposure guidelines.
• Slide the ceiling-mount base onto the drywall, sheet metal, or other screw heads until it snugs into place.
You have installed the Nortel Networks WLAN - Access Port (2230/2231). Repeat
(2230/2231) for each Nortel Networks WLAN - Access Port (2230/2231) location, and then continue with
Information.
Ceiling-Mount Clips
When you are mounting the WLAN Access Port (2230/2231) on the extruded aluminium rails of a hanging ceiling, use the
ceiling-mount clips to mount the WLAN Access Port (2230/2231) as shown in the following figure and as described below:
Figure -
Assembling the WLAN Access Port (2230/2231) and Ceiling-Mount Clips
• Copy the MAC address(es) from the label(s) on the WLAN Access Port (2230/2231) onto the corresponding location on
the map. MAC addresses have the format 000B85xxxxxx.
• Attach the ceiling-mount clips to the bottom of the WLAN Access Port (2230/2231) using the factory-supplied machine
screws and washers.
May 2004
Step 4: Mounting the WLAN Access Ports (2230/2231)
Ceiling-Mount Clips
Step 4: Mounting the WLAN Access Ports
Step 5: Returning MAC
13