Table of Contents
Advertisement
Finalizing the Installation
Fireback and Grate Installation
WARNING: Firebacks are required for this fireplace and must be installed prior to operation.
1
Remove the glass frame.
3
Remove the exhaust restrictor (see page 23). Make sure to return the restrictor to the correct position after
the firebacks are in place.
4
Install the firebacks and grate following the directions below.
5/16" Nutdriver
Place the floor
firebacks in place.
Place the grate in place. Take care to
prevent it from damaging the ceramic
firebacks.
© Travis Industries
Remove the screws and
a
clips on both sides.
d
(for qualified installers only)
Place the rear fireback in place. The side
b
fireback holds the rear fireback in place -
hold the rear fireback while installing the
side fireback.
4080214
Place the side firebacks
c
in place. Secure using
the screws and clips
removed in step "a".
100-01182_003
47
Advertisement
Table of Contents
